BPS C-100 Servisní příručka stáhnout pdf (Strana 35)

Leuze electronic Communicating with the Device

Leuze electronic BPS 37 33

TNT 35/7-24V

9.2.2 General parameter structure

Using the BPSConfig program, parameters can be changed via the service interface. These

parameters are divided into individual folders.

The following folders are available:

The various setting options are con-

tained in the folder Measurement

Value Control. These are used for

activating or deactivating the meas-

urement process.

Measurement Value

Control

Measurement Value

Preparation

This folder contains the parameters

which can be used to prepare the

measurement value. This includes

e.g. setting the initial or pre-set

value, the scaling setting, the count-

ing direction or the resolution.

Measurement value ranges can be

defined in this folder. If the meas-

urement values rise above or drop

below these values, the BPS should

respond appropriately.

Measurement Value

Monitoring

In this folder the activation and

deactivation as well as the timing of

the switching output are defined.

Switching output

Settings can be made in this folder

for controlling how the BPS reacts

to the application of a 24 V signal.

Switching input

This folder contains all settings nec-

essary for integrating the BPS to a

control or drive system via an SSI

interface.

SSI Interface

1 2 ... 30 31 32 33 34 35 36 37 38

Žádné komentáře

BPS C-100 Servisní příručka Strana 35