BPS C-100 Uživatelská příručka stáhnout pdf (Strana 17)

DUAL BATTERY CONFIGURATION CHARGING

If you are using the Battery Pack in the dual configuration you may charge

both Battery Packs at the same time.

 Connect the DC Power Pigtail Cord to the DC In Jack of both Batteries.

 Connect the DC Power Pigtail Cord to the Output Cable of the AC Power

Supply and follow the remaining charging instructions listed on

page 11 (charging with AC power) or page 12 (charging in a vehicle).

Charging the Battery Pack

Powering Your PAP Device

INTRODUCTION

The DC capability, voltage requirements and plug polarity of your PAP device

will determine how your device connects to the Battery Pack.

Some PAP devices can be connected directly to the Battery Pack via the

DC Pigtail Power Cord; while others will require the additional use of a

power inverter or power converter in order to complete the connection

between the Battery Pack and your PAP device.

Please refer to the following pages for specific setup instructions for Philips

Respironics, ResMed, Fisher & Paykel, and DeVilbiss PAP devices. Do not

attempt to connect the Battery Pack to your PAP device until you

have read and understand the following instructions. Failure to do so

may damage your PAP device.

Output Cable

of AC

Power Supply

DC Power Pigtail Cord



1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Žádné komentáře

BPS C-100 Uživatelská příručka Strana 17